HP HSR6800 Router Series - HP HSR6800-CMW520-R3103P04-RU Release Notes

RTD066547

 Symptom: The VPN multi-instance setting in an ACL does not take effect when the ACL is used in the

ip http acl command.

 Condition: This symptom occurs when the VPN multi-instance is set in the ACL.

RTD066374

 Symptom: The device in gateway mode has a poor forwarding performance.

 Condition: This symptom occurs when traffic forwarded through aggregate groups cannot trigger

the device to establish a fast-forwarding table.

Resolved Problems in CMW520-R3103P02

RTD066142

 Symptom: After the OSPF default route is deleted, the standby MPU prints the message "The default

route has been changed or deleted, protocol is OSPF", which should be output by the active MPU.

 Condition: This symptom occurs when the following conditions exist:

The router has two MPUs.

OSPF NSR is enabled.

An OSPF default route exists.

RTD066144

 Symptom: When the DHCP relay agent on the device receives a DHCP packet in which the length

value in Option 82 is larger than the actual field length, the SR6600 reboots.

 Condition: This symptom occurs when the DHCP relay agent on the device receives a DHCP packet

in which the length value in Option 82 is larger than the actual field length.

RTD066403

 Symptom: When session control is enabled on the AAA server and a RADIUS key is configured on

device, users might fail to get online.

 Condition: This symptom might occur when session control is enabled on the AAA server and a

RADIUS key is configured on device.

RTD066507

 Symptom: On an SR6616-X, the display device manuinfo fan command fails to be executed.

 Condition: This symptom occurs when you execute the display device manuinfo fan command on

an HSR6808.

RTD066571

 Symptom: When the security policy server is enabled on IMC and the device acts as the portal

gateway, an iNode client passes security policy authentication and can access the network. After

a certain time, the iNode client fails to pass security policy authentication and cannot access the

network.

 Condition: This symptom occurs when the security policy server is enabled on IMC and the device

acts as the portal gateway.