R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

102

Task Remarks

Configuring a QoS policy Required.

Applying the QoS policy to an interface Required.

Configuring the route sender

Configure the BGP route sender to set route attributes for routes before advertising them.

Configuring basic BGP functions

For more information, see Layer 3—IP Routing Configuration Guide and Layer 3—IP Routing Command

Reference.

Creating a routing policy

Configure a routing policy to classify routes and set route attributes for the route classes. For more

information, see Layer 3—IP Routing Configuration Guide and Layer 3—IP Routing Command

Reference.

Configuring the route receiver

Configure the BGP route receiver to match the route attributes set by the router sender and set the

QPPB-related attributes.

Configuring basic BGP functions

For more information, see Layer 3—IP Routing Configuration Guide and Layer 3—IP Routing Command

Reference.

Configuring a routing policy

Configure a routing policy to match the route attributes set by the route sender and set the IP precedence,

QoS-local ID, or both for the matching routes. For more information, see Layer 3—IP Routing

Configuration Guide and Layer 3—IP Routing Command Reference.

Enabling QPPB on the route receiving interface

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter interface

view.

interface interface-type

interface-number

This interface must be the one connected to

the route sender.