R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

105
Destination: 1.1.1.0/24
Protocol: BGP Process ID: 0
Preference: 255 Cost: 0
IpPrecedence: 1 QosLcId: 3
NextHop: 168.1.1.1 Interface: Serial 2/1/1
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 0.0.0.0 Neighbor : 168.1.1.1
Tunnel ID: 0x0 Label: NULL
State: Active Adv GotQ Age: 00h00m45s
Tag: 0
# Display the QoS policy configuration on port Serial 2/1/1 of Router B.
[RouterB] display qos policy interface serial 2/1/1
Interface: Serial2/1/1
Direction: Inbound
Policy: qppb
Classifier: default-class
Matched : 0(Packets) 0(Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped : 0/0 (pps/bps)
Rule(s) : If-match any
Behavior: be
-none-
Classifier: qppb
Matched : 0(Packets) 0(Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped : 0/0 (pps/bps)
Operator: AND
Rule(s) : If-match ip-precedence 1
If-match qos-local-id 3
Behavior: qppb
Committed Access Rate:
CIR 512 (kbps), CBS 32000 (byte), EBS 0 (byte)
Green Action: pass
Red Action: discard
Green : 0(Packets) 0(Bytes)
Red : 0(Packets) 0(Bytes)
QPPB configuration example in an MPLS L3VPN
Network requirements
As shown in Figure 36, all routers run BGP.
Configure QPPB, so that Router C can receive routes, set the QPPB QoS-local IDs, and use the QoS
policy to limit the traffic rate to 2 Mbps in each direction.