R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

111
Classifier: default-class
Matched : 0(Packets) 0(Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped : 0/0 (pps/bps)
Rule(s) : If-match any
Behavior: be
-none-
Classifier:
Matched : 0(Packets) 0(Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped : 0/0 (pps/bps)
Operator: AND
Rule(s) : If-match qos-local-id 1023
Behavior: qppb-l3vpn
Committed Access Rate:
CIR 2000 (kbps), CBS 125000 (byte), EBS 0 (byte)
Green Action: pass
Red Action: discard
Green : 0(Packets) 0(Bytes)
Red : 0(Packets) 0(Bytes)
QPPB configuration example in an IPv6 network
Network requirements
As shown in Figure 37, all routers run BGP.
Configure QPPB, so that Router B can receive routes and set the QPPB IP precedence. Configure a QoS
policy to limit the rate of traffic with the set IP precedence to 512 kbps.
Figure 37 Network diagram
Configuration procedure
1. Enable IPv6 globally, and configure IP addresses for each interface. (Details not shown.)
2. Configure Router A:
# Configure BGP.
<RouterA> system-view
[RouterA] bgp 1000
[RouterA-bgp] ipv6-family
[RouterA-bgp-af-ipv6] peer 168::2 as-number 2000