R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

4
Task Remarks
Configuring a basic ACL
Required.
Configure at least one task.
Basic ACLs and advanced ACLs are applicable to IPv4
and IPv6.
Configuring an advanced ACL
Configuring an Ethernet frame header ACL
Copying an ACL
Optional.
Applicable to IPv4 and IPv6.
Enabling ACL acceleration for an IPv4 basic or IPv4
advanced ACL
Optional.
Configuring a time range
You can create a maximum of 256 time ranges, each having a maximum of 32 periodic statements and
12 absolute statements. If a time range has multiple statements, its active period is calculated as follows:
1. Combining all periodic statements.
2. Combining all absolute statements.
3. Taking the intersection of the two statement sets as the active period of the time range.
To configure a time range:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a time
range.
time-range time-range-name
{ start-time to end-time days [ from
time1 date1 ] [ to time2 date2 ] |
from time1 date1 [ to time2 date2 ]
| to time2 date2 }
By default, no time range exists.
Repeat this command with the same time
range name to create multiple statements for
a time range.
Configuring a basic ACL
Configuring an IPv4 basic ACL
IPv4 basic ACLs match packets based only on source IP addresses.
To configure an IPv4 basic ACL:
Ste
p
Command Remarks
1. Enter system
view.
system-view N/A