R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

112
[RouterA-bgp-af-ipv6] network 1:: 64
[RouterA-bgp-af-ipv6] quit
[RouterA-bgp] quit
3. Configure Router B:
# Configure BGP.
<RouterB> system-view
[RouterB] bgp 2000
[RouterB-bgp] ipv6-family
[RouterB-bgp-af-ipv6] peer 168::1 as-number 1000
[RouterB-bgp-af-ipv6] peer 168::1 route-policy qppb import
[RouterB-bgp-af-ipv6] network 2:: 64
[RouterB-bgp-af-ipv6] quit
[RouterB-bgp] quit
# Configure a routing policy.
[RouterB] route-policy qppb permit node 0
[RouterB-route-policy] apply ip-precedence 4
[RouterB-route-policy] quit
# Enable QPPB on interface GigabitEthernet 1/0/1.
[RouterB] interface gigabitethernet 1/0/1
[RouterB-GigabitEthernet1/0/1] bgp-policy destination ip-prec-map
# Configure a QoS policy.
[RouterB] traffic classifier qppb
[RouterB-classifier-qppb] if-match ip-precedence 4
[RouterB-classifier-qppb] quit
[RouterB] traffic behavior qppb
[RouterB-behavior-qppb] car cir 512 red discard
[RouterB-behavior-qppb] quit
[RouterB] qos policy qppb
[RouterB-qospolicy-qppb] classifier qppb behavior qppb mode qppb-manipulation
[RouterB-qospolicy-qppb] quit
# Apply the QoS policy to the incoming traffic of GigabitEthernet 1/0/1.
[RouterB] interface gigabitethernet 1/0/1
[RouterB-GigabitEthernet1/0/1] qos apply policy qppb inbound
[RouterB-GigabitEthernet1/0/1] quit
4. Verify the configuration:
# Check whether the related routes on Router A take effect.
[RouterA] display ipv6 routing-table
Routing Table :
Destinations : 7 Routes : 7
Destination: ::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 1::/64 Protocol : Direct
NextHop : 1::1 Preference: 0
Interface : GE1/0/1 Cost : 0