R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

132
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter FR interface view.
interface interface-type
interface-number
N/A
3. Enable FRTS.
fr traffic-shaping By default, FRTS is disabled.
4. Return to system view.
quit N/A
5. Enter FR class view.
fr class class-name N/A
6. Set CBS for FR PVCs.
cbs [ outbound ]
committed-burst-size
Optional.
The default setting is 56000 bps.
7. Set EBS for FR PVCs.
ebs [ outbound ] excess-burst-size
Optional.
The default setting is 0 bit.
8. Set CIR ALLOW for FR PVCs.
cir allow [ outbound ]
committed-information-rate
Optional.
The default setting is 56000 bps.
9. Set CIR for FR PVCs.
cir committed-information-rate
Optional.
The default setting is 56000 bps.
10. Enable FRTS adaptation.
traffic-shaping adaptation { becn
percentage | interface-congestion
number }
Optional.
By default, the command is
enabled with the percentage
argument being 25 for traffic with
the BECN flag.
Configuring FR traffic policing
Configuration restrictions and guidelines
• FR traffic policing is applied to the interfaces receiving FR packets and can only be applied to the
DCE of an FR network.
• You can use the cbs, ebs, and cir allow commands to set both inbound and outbound parameters
for FR PVCs. However, only inbound parameters take effect for FR traffic policing.
Configuration procedure
To configure FR traffic policing:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter FR interface view.
interface interface-type
interface-number
N/A
3. Enable FR traffic policing.
fr traffic-policing
By default, FR traffic policing is
disabled.
4. Return to system view.
quit N/A