R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

147
A policy can be applied to multiple interfaces or PVCs, but only one policy can be applied in one
direction (inbound or outbound) of an interface or PVC.
To apply the QoS policy to an interface or PVC:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or
PVC view.
• Enter interface view:
interface interface-type
interface-number
• Enter PVC view:
a. interface atm interface-number
b. pvc vpi/vci
Settings in interface view take
effect on the current interface.
Settings in PVC view take effect on
the current PVC.
3. Apply the policy to the
interface, port group, or
PVC.
qos apply policy policy-name { inbound
| outbound }
N/A
NOTE:
The QoS policy applied to the outgoing traffic on an interface or PVC does not regulate local packets,
w
hich are critical protocol packets sent by the local system for operation maintenance. The most common
local packets include link maintenance, routing (IS-IS, BGP, and OSPF for example), RIP, LDP, and SSH
packets.
Implementing HQoS through interface-level
hierarchical CAR
Configuring CAR-list-based traffic policing
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a
committed access
rate (CAR) list.
qos carl carl-index { precedence
precedence-value | mac mac-address |
mpls-exp mpls-exp-value | dscp dscp-list |
{ destination-ip-address | source-ip-address }
{ subnet ip-address mask-length | range
start-ip-address to end-ip-address }
[ per-address [ shared-bandwidth ] ] }
Configure rules on the CAR list.
3. Enter interface
view.
interface interface-type interface-number N/A