R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

9
Ste
p
Command Remarks
3. Configure a
description for the
Ethernet frame
header ACL.
description text
Optional.
By default, an Ethernet frame header ACL has no ACL
description.
4. Set the rule
numbering step.
step step-value
Optional.
The default setting is 5.
5. Create or edit a
rule.
rule [ rule-id ] { deny |
permit } [ cos vlan-pri |
counting | dest-mac
dest-address dest-mask |
{ lsap lsap-type
lsap-type-mask | type
protocol-type
protocol-type-mask } |
source-mac source-address
source-mask | time-range
time-range-name ] *
By default
,
an Ethernet frame header ACL does not
contain any rule.
6. Add or edit a rule
comment.
rule rule-id comment text
Optional.
By default, no rule comments are configured.
7. Add or edit a rule
range remark.
rule [ rule-id ] remark text
Optional.
By default, no rule range remarks are configured.
Copying an ACL
You can create an ACL by copying an existing ACL (source ACL). The new ACL (destination ACL) has the
same properties and content as the source ACL, but not the same ACL number and name.
To successfully copy an ACL, make sure that:
• The destination ACL number is from the same category as the source ACL number.
• The source ACL already exists, but the destination ACL does not.
Copying an IPv4 basic, IPv4 advanced, or Ethernet frame
header ACL
Ste
p
Command
1. Enter system view.
system-view
2. Copy an existing IPv4
basic, IPv4 advanced,
or Ethernet frame
header ACL to create a
new ACL.
acl copy { source-acl-number | name source-acl-name } to { dest-acl-number |
name dest-acl-name }