R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

30
# Assign port priorities to GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. Make sure that the
priority of GigabitEthernet 1/0/1 is higher than GigabitEthernet 1/0/2, and no trusted packet
priority type is configured on GigabitEthernet 1/0/1 or GigabitEthernet 1/0/2.
<RouterC> system-view
[RouterC] interface gigabitethernet 1/0/1
[RouterC-GigabitEthernet1/0/1] qos priority 3
[RouterC-GigabitEthernet1/0/1] quit
[RouterC] interface gigabitethernet 1/0/2
[RouterC-GigabitEthernet1/0/2] qos priority 1
[RouterC-GigabitEthernet1/0/2] quit
Priority mapping table configuration example
Network requirements
As shown in Figure 7:
• The marketing department connects to GigabitEthernet 1/0/1 of Router, which sets the 802.1p
priority of traffic from the marketing department to 3.
• The R&D department connects to GigabitEthernet 1/0/2 of Router, which sets the 802.1p priority
of traffic from the R&D department to 4.
• The management department connects to GigabitEthernet 1/0/3 of Router, which sets the 802.1p
priority of traffic from the management department to 5.
Configure port priority, 802.1p-to-local mapping table, and priority marking to implement the plan as
described in Table 3.
Table 3 Configuration plan
Traffic
destination
Traffic priority
order
Queuin
g
p
lan
Traffic source Out
p
ut
q
ueue Queue
p
riorit
y
Public servers
R&D department >
management
department > marketing
department
R&D department 6 High
Management
department
4 High
Marketing department 2 Low
Internet
Management
department > marketing
department > R&D
department
R&D department 2 Low
Management
department
6 High
Marketing department 3 Medium