R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

39
3. Configure a CAR action for all traffic on the
interface or port group.
qos car { inbound | outbound } any cir
committed-information-rate [ cbs committed-burst-size
[ ebs excess-burst-size ] ] [ green action ] [ red action ]
Configuring GTS
GTS for software forwarding does not support IPv6.
Do not configure GTS on a main interface and its subinterfaces at the same time.
Configuring GTS by using the policy approach
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a class and
enter class view.
traffic classifier classifier-name [ operator
{ and | or } ]
N/A
3. Configure match
criteria.
if-match [ not ] match-criteria N/A
4. Return to system view.
quit N/A
5. Create a behavior and
enter behavior view.
traffic behavior behavior-name N/A
6. Configure a GTS
action.
• In absolute value:
gts cir committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size [ queue-length
queue-length ] ] ]
• In percentage:
gts percent cir cir-percent [ cbs cbs-time
[ ebs ebs-time ] ]
N/A
7. Return to system view.
quit N/A
8. Create a policy and
enter policy view.
qos policy policy-name N/A
9. Associate the class with
the traffic behavior in
the QoS policy.
classifier classifier-name behavior
behavior-name
N/A
10. Return to system view.
quit N/A
11. Apply the QoS policy.
• Applying the QoS policy to an interface
or PVC
• Applying the QoS policy to a VLAN
Choose one of the application
destinations as needed.
Configuring GTS by using the non-policy approach
When you configure GTS in non-policy approach, you can configure the following types of GTS: