R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

41
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number
Use one of the commands.
Settings in interface view take effect
on the current interface. Settings in
port group view take effect on all
ports in the port group.
3. Configure the rate limit
for the interface or port
group.
qos lr inbound cir
committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ]
N/A
Configuring packet resequencing
When the network traffic is out of sequence, some systems that cannot resequence packets, such as a
video conferencing terminal, might encounter mosaic. The packet resequencing function can alleviate the
problem.
To configure packet resequencing:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Enable packet
resequencing.
qos resequencing
By default, packet resequencing is
disabled.
After you enable or disable packet
resequencing, to make the
configuration take effect, you must
re-enable the interface by using the
shutdown and undo shutdown
command sequence.
Displaying and maintaining traffic policing, GTS,
and rate limit
Task Command Remarks
Display CAR list information.
display qos carl [ carl-index ] [ | { begin | exclude
| include } regular-expression ]
Available in any
view.
Display the CAR information on the
specified interface.
display qos car interface [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
Available in any
view.