R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

59
• To reference both the queue ef command and the queue af command in a policy, you must
configure them in the same unit (either bandwidth or percentage). If not, your referencing attempts
will fail.
To configure AF and the minimum guaranteed bandwidth:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a traffic behavior and
enter traffic behavior view.
traffic behavior behavior-name
The specified behavior name
cannot be the name of any
system-defined behavior.
3. Configure AF and the
minimum guaranteed
bandwidth.
queue af bandwidth { bandwidth |
pct percentage }
N/A
Configuring EF and the maximum bandwidth
When you configure EF and the maximum bandwidth, follow these guidelines:
• You cannot configure the queue ef command together with the any of the commands queue af,
queue-length, and wred for a traffic behavior.
• The default class cannot be associated with a traffic behavior including EF.
• To reference both the queue ef command and the queue af command in a policy, you must
configure them in the same unit (either bandwidth or percentage). If not, your referencing attempts
will fail.
To configure EF and the maximum bandwidth:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Create a traffic behavior and
enter traffic behavior view.
traffic behavior behavior-name
The specified traffic behavior name
cannot be the name of any
system-defined behavior.
3. Configure EF and the
maximum bandwidth.
queue ef bandwidth { bandwidth
[ cbs burst ] | pct percentage
[ cbs-ratio ratio] }
N/A
Configuring WFQ
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a traffic behavior and
enter traffic behavior view.
traffic behavior behavior-name
The specified traffic behavior name
cannot be the name of any
system-defined behavior.
3. Configure WFQ.
queue wfq [ queue-number
total-queue-number ]
N/A
You can associate the traffic behavior that contains a WFQ action only with the default class.