R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

75
Configure group-based WRR queuing
When a WRR queue is configured on an interface, WRR queuing is enabled on the interface, and other
queues on the interface use the default WRR scheduling value and are assigned to the default WRR
priority group.
Configuration procedure
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or
port group view.
• Enter interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Settings in interface view take effect on the
current interface. Settings in port group view
take effect on all ports in the port group.
3. Enable WRR queuing.
qos wrr
WRR queuing is only applicable to Layer 2
interfaces.
By default, an interface uses SP queuing.
4. Configure a basic WRR
queue.
qos wrr queue-id weight
schedule-value
N/A
5. Display WRR queuing
configuration
information on
interfaces.
display qos wrr interface
[ interface-type
interface-number ] [ | { begin |
exclude | include }
regular-expression ]
Optional.
Available in any view.
1. Configuring group-based WRR queuing
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or
port group view.
• Enter interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Settings in interface view take effect on the
current interface. Settings in port group view
take effect on all ports in the port group.
3. Enable WRR queuing.
qos wrr
WRR queuing is only applicable to Layer 2
interfaces.
The default queuing algorithm on an interface
varies with device models.
4. Assign a queue to a
WRR group, and
configure scheduling
parameters for the
queue.
qos wrr queue-id group 1
weight schedule-value
N/A