R3303-HP HSR6800 Routers ACL and QoS Configuration Guide

1
Configuring ACLs
Overview
An access control list (ACL) is a set of rules (or permit or deny statements) for identifying traffic based on
criteria such as source IP address, destination IP address, and port number.
ACLs are primarily used for traffic identification. The packet drop or forwarding decisions varies with the
modules that use ACLs.
ACL categories
Cate
g
or
y
ACL number IP version Match criteria
Basic ACLs 2000 to 2999
IPv4 Source IPv4 address
IPv6 Source IPv6 address
Advanced ACLs 3000 to 3999
IPv4
Source IPv4 address, destination IPv4 address,
packet priority, protocol number, and other
Layer 3 and Layer 4 header fields
IPv6
Source IPv6 address, destination IPv6 address,
packet priority, protocol number, and other
Layer 3 and Layer 4 header fields
Ethernet frame
header ACLs
4000 to 4999 N/A
Layer 2 header fields, such as source and
destination MAC addresses, 802.1p priority,
and link layer protocol type
Numbering and naming ACLs
Each ACL category has a unique range of ACL numbers. You can assign the ACL a name for ease of
identification. After creating an ACL with a name, you cannot rename it or delete its name.
For an IPv4 basic or advanced ACLs, its ACL number and name must be unique in IPv4, and for an IPv6
basic or advanced ACL, its ACL number and name must be unique in IPv6.
Match order
The rules in an ACL are sorted in a specific order. When a packet matches a rule, the device stops the
match process and performs the action defined in the rule. If an ACL contains overlapping or conflicting
rules, the matching result and action to take depend on the rule order.
The following ACL match orders are available:
• config—Sorts ACL rules in ascending order of rule ID. A rule with a lower ID is matched before a
rule with a higher ID. If you use this method, check the rules and their order carefully.