R3303-HP HSR6800 Routers Fundamentals Command Reference

43
stopbits
Use stopbits to specify the number of stop bits for a character.
Use undo stopbits to restore the default.
Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
Default
One stop bit is used.
Views
User interface view
Default command level
2: System level
Parameters
1: Uses one stop bit.
1.5: Uses one and a half stop bits.
2: Uses two stop bits.
Usage guidelines
This command is only applicable to asynchronous serial interfaces, including AUX and console ports.
The configuration terminal and the device must be configured to use the same number of stop bits to
communicate.
Examples
# Set the number of stop bits to 1.5 for user interface AUX 0.
<Sysname> system-view
[Sysname] user-interface aux 0
[Sysname-ui-aux0] stopbits 1.5
telnet
Use telnet to Telnet to a host in an IPv4 network.
Syntax
telnet remote-host [ service-port ] [ vpn-instance vpn-instance-name ] [ source { interface interface-type
interface-number | ip ip-address } ]
Views
User view
Default command level
0: Visit level