R3303-HP HSR6800 Routers Fundamentals Command Reference

47
Usage guidelines
The device supports two terminal display types: ANSI and VT100. HP recommends that you set the
display type to VT100 on both the device and the configuration terminal. If either side uses the ANSI type,
a display problem such as cursor positioning error might occur when a command line has more than 80
characters.
Examples
# Set the terminal display type to VT100.
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] terminal type vt100
user privilege level
Use user privilege level to configure the user privilege level. Users logging into the user interface are
assigned a user privilege level.
Use undo user privilege level to restore the default.
Syntax
user privilege level level
undo user privilege level
Default
The command level is 3 for the console user interface and 0 for other user interfaces.
Views
User interface view
Default command level
3: Manage level
Parameters
level: Specifies a user privilege level in the range of 0 to 3.
Usage guidelines
User privilege levels include visit, monitor, system, and manage, represented by the number 0, 1, 2 and
3 respectively. You can change the user privilege level when necessary.
This command is not available in FIPS mode.
Examples
# Set the command level for users logging in through VTY 0 to 0.
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 0
After you Telnet to the device through VTY 0, the terminal only displays commands of level 0 in the help
information:
<Sysname> ?
User view commands:
cluster Run cluster command