R3303-HP HSR6800 Routers Fundamentals Configuration Guide

108
Task Command Remarks
Specify a next-startup
configuration file.
startup saved-configuration
cfgfile [ backup | main ]
The setting applies to both active MPU and
standby MPU.
On an IRF fabric, the setting applies to all
MPUs.
IMPORTANT:
The configuration file must use the .cfg
extension and be saved in the root directory of
a storage medium.
Backing up the next-startup configuration file to a
TFTP server
Before performing this task, make sure the following requirements are met:
• The server is reachable and enabled with TFTP service.
• You have read and write permissions.
This task backs up only the main next-startup configuration file.
To back up the main next-startup configuration file to a TFTP server:
Step Command Remarks
1. Verify that a next-startup
configuration file has
been specified in user
view.
display startup
Optional.
If no next-startup configuration file has
been specified, the backup operation will
fail.
2. Back up the next-startup
configuration file to a TFTP
server in user view.
backup startup-configuration
to dest-addr [dest-filename ]
This command is not supported in FIPS
mode.
.
Restoring the next-startup configuration file from a
TFTP server
Perform this task to download a configuration file from a TFTP server to the root directory of a storage
medium on each MPU and specify the file as the next-startup configuration file in one step.
NOTE:
This task restores only the main next-startup configuration file.
Before restoring the next-startup configuration file, make sure the following requirements are met:
• The server is reachable and enabled with TFTP service.
• You have read and write permissions.
To restore the main next-startup configuration file from a TFTP server: