R3303-HP HSR6800 Routers Fundamentals Configuration Guide

120
Ste
p
Command
1. Enter system view.
system-view
2. Load a patch file from the
patch loading location to
the patch memory area.
patch load slot slot-number [ file patch-package ]
To load patches in IRF mode:
Ste
p
Command
1. Enter system view.
system-view
2. Load a patch file from the
patch loading location to the
patch memory area.
patch load chassis chassis-number slot slot-number [ file patch-package ]
Activating patches
Activating a patch changes its state to ACTIVE. An ACTIVE patch runs in memory until a reboot occurs.
To have a patch continue to run after a reboot, you must change its state to RUNNING.
To activate patches in standalone mode:
Ste
p
Command
1. Enter system view.
system-view
2. Activate patches.
patch active [ patch-number ] slot slot-number
To activate patches in IRF mode:
Ste
p
Command
1. Enter system view.
system-view
2. Activate patches.
patch active [ patch-number ] chassis chassis-number slot slot-number
Confirming ACTIVE patches
To have an ACTIVE patch continue to run after a reboot, perform the task in this section.
After you confirm an ACTIVE patch, its state changes to RUNNING and persists after a reboot.
To confirm ACTIVE patches in standalone mode:
Ste
p
Command
1. Enter system view.
system-view
2. Confirm ACTIVE patches.
patch run [ patch-number ] [ slot slot-number ]
To confirm ACTIVE patches in IRF mode:
Ste
p
Command
1. Enter system view.
system-view