R3303-HP HSR6800 Routers Fundamentals Configuration Guide

133
Disabling password recovery capability
Password recovery capability controls console user access to the device configuration and SDRAM from
BootWare menus.
If password recovery capability is enabled, a console user can access the device configuration without
authentication to reconfigure new passwords.
If password recovery capability is disabled, a console user must restore the factory-default configuration
before configuring new passwords. Restoring the factory-default configuration deletes the main and
backup next-startup configuration files.
To enhance system security:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Disable password
recovery capability.
undo password-recovery
enable
By default, password recovery capability is
enabled.
Configuring the exception handling method
You can configure the device to handle system exceptions in one of the following methods:
• reboot—Automatically reboots the failed MPU to recover from the error condition.
• maintain—Stays in the error condition so you can collect complete data, including error messages,
for diagnosis. With this method, you must manually reboot the device.
To configure the exception handling method in standalone mode:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the exception
handling method for the MPU.
system-failure { maintain | reboot }
Optional.
By default, the MPU uses the reboot
method when an exception occurs.
The device always reboots an
interface card or the auxiliary CPU
system when an exception occurs
to them.
To configure the exception handling method in IRF mode:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A