R3303-HP HSR6800 Routers Fundamentals Configuration Guide

30
Ste
p
Command Remarks
9. Set an authentication
password for the local user.
password [ [ hash ] { cipher |
simple } password ]
By default, no password is set.
10. Specifies a command level
of the local user.
authorization-attribute level level
Optional.
By default, the command level is 0.
11. Specify terminal service for
the local user.
service-type terminal
By default, no service type is
specified.
12. Configure common settings
for console login.
See "Configuring common console
user interface s
ettings (optional)."
Optional.
The next time you attempt to log in through the console port, you must provide the configured login
username and password, as shown in Figure 11.
Figure 11 Schem
e authentication interface for console login
Configuring common console user interface settings (optional)
Some common settings configured for a console user interface take effect immediately and can interrupt
the console login session. To save you the trouble of repeated re-logins, use a login method different from
console login to log in to the device before you change console user interface settings.
After the configuration is complete, change the terminal settings on the configuration terminal and make
sure they are the same as the settings on the device.
To configure common settings for a console user interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter console user interface
view.
user-interface console first-number
[ last-number ]
N/A