R3303-HP HSR6800 Routers Fundamentals Configuration Guide

38
Ste
p
Command Remarks
3. Enable the terminal service.
shell
Optional.
By default, terminal service is
enabled.
4. Enable the user interfaces to
support Telnet, SSH, or both of
them.
protocol inbound { all | ssh |
telnet }
Optional.
By default, both Telnet and SSH
are supported.
The configuration takes effect the
next time you log in.
5. Define a shortcut key for
terminating tasks.
escape-key { default |
character }
Optional.
By default, pressing Ctrl+C
terminates a task.
6. Configure the type of terminal
display.
terminal type { ansi | vt100 }
Optional.
By default, the terminal display
type is ANSI.
The device supports two terminal
display types: ANSI and VT100.
HP recommends that you set the
display type to VT100 on both the
device and the configuration
terminal. If either side uses the
ANSI type, a display problem such
as cursor positioning error might
occur when a command line has
more than 80 characters.
7. Set the maximum number of lines
to be displayed on a screen.
screen-length screen-length
Optional.
By default, up to 24 lines is
displayed on a screen.
A value of 0 disables the function.
8. Set the size of command history
buffer.
history-command max-size
value
Optional.
By default, the buffer saves 10
history commands.
9. Set the idle-timeout timer.
idle-timeout minutes [ seconds ]
Optional.
The default idle-timeout is 10
minutes for all user interfaces.
The system automatically
terminates the user's connection if
there is no information interaction
between the device and the user
within the timeout time.
Setting idle-timeout to 0 disables
the timer.