R3303-HP HSR6800 Routers Fundamentals Configuration Guide
42
Ste
p
Command
Remarks
10. Apply an AAA authentication
scheme to the intended
domain.
a. Enter the ISP domain view:
domain domain-name
b. Apply the specified AAA
scheme to the domain:
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name
[ local ] | local | none |
radius-scheme
radius-scheme-name
[ local ] }
c. Exit to system view:
quit
Optional.
For local authentication, configure
local user accounts.
For RADIUS or HWTACACS
authentication, configure the
RADIUS or HWTACACS scheme
on the device and configure
authentication settings (including
the username and password) on
the server.
For more information about AAA
configuration, see Security
Configuration Guide.
11. Create a local user and enter
local user view.
local-user user-name By default, no local user exists.
12. Set a password for the local
user.
password [ [ hash ] { cipher |
simple } password ]
By default, no password is set.
13. Specify the command level of
the user.
authorization-attribute level level
Optional.
By default, the command level is 0.
14. Specify SSH service for the
user.
service-type ssh
By default, no service type is
specified.
15. Exit to system view.
quit N/A
16. Create an SSH user, and
specify the authentication
mode for the SSH user.
ssh user username service-type
stelnet authentication-type
{ password | { any |
password-publickey | publickey }
assign publickey keyname }
N/A
17. Configure common settings
for VTY user interfaces.
See "Configuring common VTY
user interface s
ettings (optional)."
Optional.
Using the device to log in to an SSH server
You can use the device as an SSH client to log in to an SSH server. If the server is located in a different
subnet than the device, make sure the two devices have routes to reach each other.
Figure 18 Logging in to an SSH client from the device
Perform the following tasks in user view:
Task Command
Remarks
Log in to an IPv4 SSH server. ssh2 server
The server argument represents the IPv4 address or
host name of the server.