R3303-HP HSR6800 Routers Fundamentals Configuration Guide

50
Ste
p
Command Remarks
15. Set the idle-timeout timer.
idle-timeout minutes [ seconds ]
The default idle-timeout is 10
minutes. The system automatically
terminates the user's connection if
there is no information interaction
between the device and the user in
timeout time.
Setting idle-timeout to 0 disables
the timer.
16. Enable Telnet redirect for the
current user interface.
redirect enable
By default, the redirect function is
disabled.
17. Specify a Telnet redirect
listening port.
redirect listen-port port-number
The default port number is the
absolute user interface number plus
2000.
18. Disable Telnet option
negotiation during redirecting
a Telnet connection.
redirect refuse-negotiation
By default, Telnet option
negotiation is enabled.
19. Configure the user interface to
not convert the ASCII
characters 0xff during
redirecting a Telnet connection.
redirect refuse-teltransfer
By default, the user interface
converts the ASCII characters 0xff
to 0xff 0xff when redirecting a
Telnet connection.
20. Configure the user interface to
change carriage returns 0x0d
0x0a and 0x0d 0x00 received
from Telnet clients to 0x0d
during redirecting a Telnet
connection.
redirect return-deal from-telnet
By default, the user interface does
not change carriage returns
received from Telnet clients during
redirecting a Telnet connection.
21. Configure the user interface to
change carriage returns 0x0d
0x0a and 0x0d 0x00 received
from a terminal (a PC
connected to the console port
for example) to 0x0d during
redirecting a Telnet connection.
redirect return-deal
from-terminal
By default, the user interface does
not change carriage returns
received from a terminal during
redirecting a Telnet connection.
22. Set the idle timeout timer for
Telnet redirect.
redirect timeout time
360 seconds by default.
If no data is received from a Telnet
client before the timer expires, the
user interface terminates the
redirected connection.
23. Manually terminate redirected
Telnet connections.
redirect disconnect N/A
The port properties of the terminal emulation program must be the same as the default settings of the AUX
port, which are shown in the following table:
Parameter Default
Bits per second 9600 bps