R3303-HP HSR6800 Routers Fundamentals Configuration Guide

Parameter Default

Flow control

• Independent AUX port: On

• Console and AUX integrated port: Off

Parity None

Stop bits 1

Data bits 8

To log in through the AUX port:

• Complete the authentication settings on the AUX user interface. By default, password authentication

is enabled, but no password is set. To use password authentication, you must set a password for

password authentication.

• Make sure the configuration terminal has a terminal emulation program (for example,

HyperTerminal in Windows XP).

• Port settings of the terminal emulation program must be the same as the settings of the AUX

port. Table 17 lists the de

fault AUX port properties.

Table 17 Default AUX port properties

Parameter Default

Bits per second 9600 bps

Flow control Hardware

Parity None

Stop bits 1

Data bits 8

To log in through the AUX port from the configuration terminal (for example, a PC):

1. Connect the DB-9 female connector of the console cable to the serial port of the PC.

2. Connect the RJ-45 connector of the console cable to the AUX port of the device.

IMPORTANT:

• Identify the mark on the AUX port and make sure you are connecting to the correct port.

• The serial ports on PCs do not support hot swapping. If the switch has been powered on, always

connect the console cable to the PC before connecting it to the device, and when you disconnect the

cable, first disconnect it from the device.

Figure 23 Connecting the AUX port to a terminal

3. If the PC is off, turn on the PC.