R3303-HP HSR6800 Routers Fundamentals Configuration Guide

57
Figure 32 Login page
9. At the default user view prompt <HP>, enter commands to configure the device or check the
running status of the device. To get help, enter ?.
IMPORTANT:
Do not directly close the HyperTerminal. Doing so can cause some modems to stay in use, and your
subsequent dial-in attempts will always fail.
To disconnect the PC from the device, execute the ATH command in the HyperTerminal. If the command
cannot be entered, type AT+ + + and then press Enter. When the word "OK" appears, execute the ATH
command. The connection is terminated if "OK" is displayed. You can also terminate the connection by
clicking in the HyperTerminal window.
Configuring none authentication for modem dial-in
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter one or more AUX user
interface views.
user-interface aux first-number
[ last-number ]
N/A
3. Enable none authentication
mode.
authentication-mode none
By default, modem users can dial
in to the device without
authentication.
4. Configure common settings
for the AUX user interfaces.
See "Configuring common settings
for modem di
al-in (optional)."
Optional.
The next time you attempt to dial in to the device, you do not need to provide any username or password,
as shown in Figure 33.