R3303-HP HSR6800 Routers Fundamentals Configuration Guide

63
Ste
p
Command Remarks
11. Configure the flow control
mode.
flow-control { hardware | none |
software }
flow-control hardware
flow-control-type1 [ software
flow-control-type2 ]
flow-control software
flow-control-type1 [ hardware
flow-control-type2 ]
The default flow control mode is
hardware.
12. Configure the type of
terminal display.
terminal type { ansi | vt100 }
By default, the terminal display type
is ANSI.
The device supports two terminal
display types: ANSI and VT100. HP
recommends that you set the display
type to VT100 on both the device
and the configuration terminal. If
either side uses the ANSI type, a
display problem such as cursor
positioning error might occur when
a command line has more than 80
characters.
13. Configure the user privilege
level for login users.
user privilege level level 0 by default.
14. Set the maximum number of
lines to be displayed on a
screen.
screen-length screen-length
By default, a screen displays 24
lines at most.
A value of 0 disables the function.
15. Set the size of the command
history buffer.
history-command max-size value
By default, the buffer saves 10
history commands at most.
16. Set the idle-timeout timer.
idle-timeout minutes [ seconds ]
The default idle-timeout is 10
minutes. The system automatically
terminates the user's connection if
there is no information interaction
between the device and the user
within the idle-timeout time.
Setting idle-timeout to 0 disables the
timer.
17. Set the maximum interval
allowed between off-hook
and dialing.
modem timer answer time
By default, the interval is 60
seconds.
18. Configure a modem to
operate in auto-answer
mode.
modem auto-answer
By default, a modem operates in
non-auto answer mode.
19. Enable modem
call-in/call-out on the user
interface.
modem { both | call-in | call-out }
By default, both modem call-in and
call-out are disabled.
20. Enable Telnet redirect for the
current user interface.
redirect enable
By default, the redirect function is
disabled.