R3303-HP HSR6800 Routers High Availability Command Reference

101
Default
The steering protection mode is used.
Views
Layer 3 RPR logical interface view
Default command level
2: System level
Parameters
steer: Sets the protection mode to steering where the source station directs protected frames to the ringlet
that retains connectivity to their destinations.
wrap: Sets the protection mode to wrapping where protected traffic is directed at the point of failure to
the opposing ringlet.
Examples
# Adopt the wrapping protection mode on the station of Layer 3 RPR logical interface RPR 1.
<Sysname> system-view
[Sysname] interface rpr 1
[Sysname-RPR1] rpr protect-mode wrap
rpr rate-limiter
Use rpr rate-limiter to configure reserved bandwidth or rate limit for traffic of a certain service class on
the specified ringlet.
Use undo rpr rate-limiter to restore the default.
Syntax
rpr rate-limiter { high | low | medium | reserved } { ringlet0 | ringlet1 } value
undo rpr rate-limiter { high | low | medium | reserved } { ringlet0 | ringlet1 }
Default
The defaults in permillage for different services are as follows:
• 0 for subclass A0
• 2 for subclass A1
• 0 for class B CIR
• 1000 for classes C and B –EIR
Views
Layer 3 RPR logical interface view
Default command level
2: System level
Parameters
high: Configures the rate limit for subclass A1 traffic.
low: Configures the rate limit for class B EIR and class C traffic.