R3303-HP HSR6800 Routers High Availability Command Reference

109
RRPP configuration commands
The router supports RRPP commands only when the SAP module is operating in bridge mode.
control-vlan
Use control-vlan to configure the primary control VLAN for the current RRPP domain.
Use undo control-vlan to remove the control VLAN configuration for the current RRPP domain.
Syntax
control-vlan vlan-id
undo control-vlan
Default
No primary control VLAN exists in the RRPP domain.
Views
RRPP domain view
Default command level
2: System level
Parameters
vlan-id: Specifies the ID of the primary control VLAN for the RRPP domain, in the range of 2 to 4093.
Usage guidelines
When configuring control VLANs for an RRPP domain, you only need to configure the control VLAN for
the primary ring (the primary control VLAN). The system automatically configures the VLAN whose VLAN
ID is the primary control VLAN ID plus 1 as the secondary control VLAN for subrings. Like the primary
control VLAN, the secondary control VLAN must be not yet created. For the control VLAN configuration
to succeed, make sure that the IDs of the two control VLANs have not been assigned yet.
Before configuring RRPP rings for an RRPP domain, you can delete or modify the control VLANs
configured for the RRPP domain. However, after configuring RRPP rings for an RRPP domain, you cannot
delete or modify the control VLANs of the domain.
You cannot use the undo vlan all command to delete a control VLAN.
Examples
# Configure VLAN 100 (VLAN 100 and VLAN 101 are non-existent VLANs) as the primary control VLAN
of RRPP domain 1.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
Related commands
rrpp domain