R3303-HP HSR6800 Routers High Availability Command Reference

131
undo port smart-link group group-id
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
group-id: Specifies the smart link group ID in the range of 1 to 48.
master: Specifies the port as the primary port.
slave: Specifies the port as the secondary port.
Usage guidelines
Disable the spanning tree feature and RRPP on the ports you want to add to the smart link group, and
make sure that the ports are not member ports of any aggregation group or service loopback group. You
cannot enable the spanning tree feature or RRPP on a smart link group member port or assign a smart
link group member port to an aggregation group or service loopback group.
You can assign a port to a smart link group with the port
command in smart link group view.
Examples
# Configure GigabitEthernet 3/0/1 as the primary port of smart link group 1.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] protected-vlan reference-instance 0
[Sysname-smlk-group1] quit
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] undo stp enable
[Sysname-GigabitEthernet3/0/1] port smart-link group 1 master
# Configure Layer 2 aggregate interface 1 as the primary port of smart link group 1.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] protected-vlan reference-instance 0
[Sysname-smlk-group1] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] undo stp enable
[Sysname-Bridge-Aggregation1] port smart-link group 1 master
Related commands
port
port smart-link group track
Use port smart-link group track to configure the collaboration between a smart link group member port
and the CC function of CFD.
Use undo port smart-link group track to remove the collaboration.
Syntax
port smart-link group group-id track cfd cc