R3303-HP HSR6800 Routers High Availability Command Reference

135
Syntax
reset smart-link statistics
Views
User view
Default command level
2: System level
Examples
# Clear the statistics about flush messages.
<Sysname> reset smart-link statistics
smart-link flush enable
Use smart-link flush enable to configure a receive control VLAN (a VLAN for receiving flush messages).
Use undo smart-link flush enable to disable flush message processing.
Syntax
smart-link flush enable [ control-vlan vlan-id-list ]
undo smart-link flush enable [ control-vlan vlan-id-list ]
Default
Flush messages are not processed.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
control-vlan vlan-id-list: Specifies the control VLANs used for receiving flush messages. The vlan-id-list is
expressed in the form of vlan-id-list = { vlan-id [ to vlan-id ] }&<1-10>, where the vlan-id argument
represents the ID of a control VLAN and is in the range of 1 to 4094. &<1-10> indicates that you can
provide up to ten VLAN IDs or VLAN ID lists.
Usage guidelines
If no VLAN is specified, VLAN 1 applies.
Do not use this command on the member port of an aggregation group or service loopback group.
Examples
# Enable GigabitEthernet 3/0/1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] smart-link flush enable
# Enable Layer 2 aggregate interface 1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] smart-link flush enable