R3303-HP HSR6800 Routers High Availability Command Reference

179
vrrp ipv6 vrid timer advertise
Use vrrp ipv6 vrid timer advertise to configure the Adver_Timer of the specified VRRP group.
Use undo vrrp ipv6 vrid timer advertise to restore the default.
Syntax
vrrp ipv6 vrid virtual-router-id timer advertise adver-interval
undo vrrp ipv6 vrid virtual-router-id timer advertise
Default
The Adver_Timer is 100 centiseconds.
Views
Interface view
Default command level
2: System level
Parameters
virtual-router-id: VRRP group number in the range of 1 to 255.
adver-interval: Interval at which the master in the specified VRRP group sends VRRP advertisements. The
value range for the argument is 100 to 4095 centiseconds.
Usage guidelines
The Adver_Timer controls the interval at which the master sends VRRP packets.
Before executing the command, create a VRRP group on an interface and configure the virtual IPv6
address of the VRRP group.
Routers in the same VRRP group must use the same Adver_Timer setting.
Examples
# Set the master in VRRP group 1 to send VRRP advertisements at intervals of 500 centiseconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] vrrp ipv6 vrid 1 virtual-ip fe80::2 link-local
[Sysname-GigabitEthernet1/0/1] vrrp ipv6 vrid 1 timer advertise 500
Related commands
display vrrp ipv6
vrrp ipv6 vrid track
Use vrrp ipv6 vrid track to associate an IPv6 VRRP group with a track entry and control master switchover
or AVF switchover in the VRRP group in response to changes (such as uplink state changes) detected by
the track entry.
Use undo vrrp ipv6 vrid track to remove the association between an IPv6 VRRP group and a track entry.
If no track entry is specified, the association between the VRRP group and any track entry is removed.