R3303-HP HSR6800 Routers High Availability Configuration Guide

14
Configuring errored frame period event detection
An errored frame period event occurs if the number of frame errors in a specific number of received
frames exceeds the predefined threshold.
To configure errored frame period event detection:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the errored frame
period event detection period.
oam errored-frame-period period
period-value
Optional.
1000 milliseconds by default.
3. Configure the errored frame
period event triggering
threshold.
oam errored-frame-period
threshold threshold-value
Optional.
1 by default.
Configuring errored frame seconds event detection
An errored frame seconds event occurs when the number of error frame seconds detected on a port
during a detection interval exceeds the error threshold.
IMPORTANT:
Make sure the errored frame seconds tri
gg
erin
g
threshold is less than the errored frame seconds detection
interval. Otherwise, no errored frame seconds event can be generated.
To configure errored frame seconds event detection:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the errored frame
seconds event detection
interval.
oam errored-frame-seconds period
period-value
Optional.
60 seconds by default.
3. Configure the errored frame
seconds event triggering
threshold.
oam errored-frame-seconds
threshold threshold-value
Optional.
1 by default.
Configuring Ethernet OAM remote loopback
CAUTION:
The Ethernet OAM remote loopback function can impact other services. Use it with caution.
When you enable Ethernet OAM remote loopback on a port, the port sends Loopback Control
OAMPDUs to a remote port, and the remote port enters the loopback state. The port then sends test
frames to the remote port. By observing how many of these test frames return, you can calculate the
packet loss ratio on the link and evaluate the link performance.