R3303-HP HSR6800 Routers Interface Configuration Guide

7
Step Command
2. Change the link mode of the specified
Ethernet interfaces.
port link-mode { bridge | route } interface-list
To change the link mode of an Ethernet interface:
Step Command
1. Enter system view.
system-view
2. Enter Ethernet interface view.
interface interface-type interface-number
3. Change the link mode of the Ethernet
interface.
port link-mode { bridge | route }
Setting a statistics polling interval
You can configure an interface statistics polling interval. To display the interface statistics collected in the
last polling interval, use the display interface or display counters rate command. To clear the interface
statistics of an interface, use the reset counters interface command.
To set the statistics polling interval:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Set the statistics polling
interval.
flow-interval interval
The default setting is 300
seconds.
When a large amount of
logical interfaces are
configured on the router, the
default setting is
recommended.
Enabling subinterface rate statistics collection on an Ethernet
interface
CAUTION:
Use this function with caution, because it might consume a large amount of system resources.
After you enable subinterface rate statistics collection on an Ethernet interface, the device periodically
refreshes the rate statistics on the subinterfaces of this Ethernet interface. You can use the display
interface command to view the rate statistics.
To enable subinterface rate statistics collection on an Ethernet interface:
Step Command Remarks
1. Enter system view.
system-view N/A