R3303-HP HSR6800 Routers Interface Configuration Guide

8
Step Command Remarks
2. Enter Ethernet interface view.
interface interface-type
interface-number
N/A
3. Enable subinterface rate
statistics collection on the
Ethernet interface.
sub-interface rate-statistic
By default, subinterface rate
statistics collection is disabled.
Configuring a Layer 2 Ethernet interface
The features in this section are supported on only SAP modules that are operating in bridge mode.
Layer 2 Ethernet interface configuration task list
You can perform the following configurations on Ethernet interfaces operating in bridge mode.
Task Remarks
Configuring a port group
Optional.
Applicable to Layer 2 Ethernet interfaces.
Setting speed options for auto negotiation on an Ethernet
interface
Optional.
Applicable to FE or GE Layer 2 Ethernet
interfaces.
Configuring storm suppression
Optional.
Applicable to Layer 2 Ethernet interfaces.
Configuring jumbo frame support
Optional.
Applicable to Layer 2 Ethernet interfaces.
Enabling loopback detection on an Ethernet interface
Optional.
Applicable to Layer 2 Ethernet interfaces.
Setting the MDI mode of an Ethernet interface
Optional.
Applicable to Layer 2 Ethernet interfaces.
Testing the cable connection of an Ethernet interface
Optional.
Applicable to Layer 2 Ethernet interfaces.
Configuring storm control on an Ethernet interface
Optional.
Applicable to Layer 2 Ethernet interfaces.
Configuring a port group
Some interfaces on your device might use the same set of settings. To configure these interfaces in bulk
rather than one by one, you can assign them to a port group.