R3303-HP HSR6800 Routers Interface Configuration Guide

47
Step Command Remarks
14. Place a T1 line on the far-end
CT3 interface in a loopback.
t1 line-number sendloopcode
{ fdl-ansi-line-up |
fdl-ansi-payload-up |
fdl-att-payload-up |
inband-line-up }
Optional.
15. Set the FDL format for a T1
channel.
t1 line-number set fdl { ansi | att |
both | none }
Optional.
By default, FDL is disabled.
This operation applies only to T1
channels that are formed on CT3
interfaces, operate in channelized
mode, and use ESF as the T1
framing format.
16. Set the intended bandwidth
for the CT3 interface.
bandwidth bandwidth-value Optional.
17. Return to system view.
quit N/A
18. Enter synchronous serial
interface view of an interface
formed by a CT3 interfaces.
• interface serial
number/line-number:0
• interface serial
number/line-number
: set-numb
er
N/A
19. Set the CRC mode.
crc { 16 | 32 | none }
Optional.
By default, 16-bit CRC is adopted..
Note:
FEAC = Far end and control signal; MDL = Maintenance data link; PPR = Periodical performance report
Displaying and maintaining CT3 interfaces
Task Command Remarks
Display the state information of
CT3 interface.
display controller t3
[ interface-number ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display the configuration and state
of a serial interface formed on a
CT3 interface.
display interface serial
interface-number [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Clear the controller counter of a
CT3 interface.
reset counters controller t3
interface-number
Available in user view.
Display the state of a T1 line. t1 line-number show
Available in CT3 interface
view.