R3303-HP HSR6800 Routers Interface Configuration Guide

62
To configure a CPOS interface:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter CPOS interface view.
controller cpos cpos-number N/A
3. Set the interface description.
description text
Optional.
By default, the description of a
CPOS interface is interface name
Interface, for example,
Cpos5/1/0 Interface.
4. Set the framing format.
frame-format { sdh | sonet }
Optional.
SDH by default.
5. Set the clock mode.
clock { master | slave }
Optional.
Slave by default.
6. Set the loopback mode.
loopback { local | remote }
Optional.
Disabled by default.
7. Configure the AUG
multiplexing mode.
multiplex mode { au-3 | au-4 }
Optional.
Available only in SDH framing.
AU-4 by default.
8. Configure the SOH and
higher-order path overhead
bytes
flag { c2 path-number c2-value | s1
s1-value | s1s0 path-number
s1s0-value }
Optional.
flag { j0 | j1 path-number } { sdh |
sonet } flag-value
9. Set the physical state change
suppression interval on the
interface.
link-delay seconds
Optional.
By default, physical state change
suppression interval is disabled on
the interface.
10. Set the intended bandwidth
for the CPOS interface.
bandwidth bandwidth-value Optional.
11. Shut down the CPOS
interface.
shutdown
Optional.
Up by default.
12. Set the signal degrade (SD) or
signal fail (SF) alarm threshold
for the interface.
threshold { sd | sf } value
Optional.
By default, the SD alarm threshold
is 10e-6 (the value argument is 6),
and the SF alarm threshold is
10e-3 (the value argument is 3).
13. Configure E1/T1/E3/T3
channel attributes.
• See "Configuring an E1
channel."
• See "Configuring a T1
channel."
• See "Configuring an E3
channel."
• See "Configuring a T3
channel."
Optional.