R3303-HP HSR6800 Routers Interface Configuration Guide

3
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter 10-GE interface view.
interface ten-gigabitethernet
interface-number
N/A
3. Configure the 10-GE interface
to operate in LAN or WAN
mode.
port-mode { lan | wan }
Optional.
By default, a 10-GE interface
operates in LAN mode.
4. Configure the J0 or J1 byte
when the 10-GE interface is
operating in WAN mode.
flag { j0 | j1 } sdh flag-value
Optional.
By default, the value of the J0 and
J1 bytes is 0.
The flag command is applicable to 10-GE interfaces operating in WAN mode only.
Configuring basic settings of an Ethernet interface or
subinterface
Configuring an Ethernet interface
You can set an Ethernet interface to operate in one of these duplex modes:
• Full-duplex mode (full)—Interfaces that operate in this mode can send and receive packets
simultaneously.
• Half-duplex mode (half)—Interfaces that operate in this mode cannot send and receive packets
simultaneously.
• Auto-negotiation mode (auto)—Interfaces that operate in this mode negotiate a duplex mode with
their peers.
You can set the speed of an Ethernet interface or enable it to automatically negotiate a speed with its
peer. For a 100-Mbps or 1000-Mbps Layer 2 Ethernet interface, you can also set speed options for auto
negotiation. The two ends can select a speed only from the available options. For more information, see
"Setting speed options for auto negotiation on an Ethernet interface."
To configure an Ethernet interface:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Ethernet interface
view.
interface interface-type
interface-number
N/A
3. Set the interface
description.
description text
Optional.
By default, the description of an interface is
in the format of interface-name Interface.
For example, GigabitEthernet 4/0/1
Interface.