R3303-HP HSR6800 Routers Interface Configuration Guide

79
Follow these guidelines when you configure the operating mode of an E-CPOS interface/channel:
• oc-48 and oc-48c correspond to 2.5 Gbps E-CPOS interfaces.
• oc-12 and oc-12c correspond to 622 Mbps E-CPOS interfaces or 622 Mbps channels channelized
from 2.5 Gbps E-CPOS interfaces.
• oc-3 and oc-3c correspond to 155 Mbps E-CPOS interfaces or 155 Mbps channels channelized
from 2.5 Gbps E-CPOS interfaces or 622 Mbps E-CPOS interfaces.
Configuring the interface/channel operating mode on a 2.5 Gbps E-CPOS interface
You can use the using command to configure a 2.5 Gbps E-CPOS interface to operate in channelized
mode or concatenated mode. To create POS channels, configure the concatenated mode. On a 2.5
Gbps E-CPOS interface in concatenated mode, you can create sixteen 155 Mbps channels, four 622
Mbps channels, or one 2.5 Gbps POS channel.
1. Create a 622 Mbps POS channel and configure its operating mode
To create a 622 Mbps POS channel and configure its operating mode on a 2.5 Gbps E-CPOS
interface:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter E-CPOS interface view.
controller e-cpos
e-cpos-number
N/A
3. Create a 622 Mbps channel
and enter its view.
oc-12 oc-12-number N/A
4. Configure the 622 Mbps
channel to operate in
concatenated mode
using oc-12c The default is the channelized mode.
2. Create a 155 Mbps POS channel and configure its operating mode
To create a 155 Mbps POS channel and configure its operating mode on a 2.5 Gbps E-CPOS
interface:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter E-CPOS interface view.
controller e-cpos
e-cpos-number
Make sure the 2.5 Gbps E-CPOS
interface is operating in concatenated
mode.
3. Enter OC-12 view (the view of
a 622 Mbps channel).
oc-12 oc-12-number
If the specified channel does not exist,
the command creates the channel first.