R3303-HP HSR6800 Routers IP Multicast Command Reference

1
IGMP snooping configuration commands
The commands in this chapter are supported only when the SAP module is operating in bridge mode.
display igmp-snooping group
Use display igmp-snooping group to display IGMP snooping group information, including both dynamic
entries and static entries.
Syntax
In standalone mode:
display igmp-snooping group [ vlan vlan-id ] [ slot slot-number ] [ verbose ] [ | { begin | exclude |
include } regular-expression ]
In IRF mode:
display igmp-snooping group [ [ vlan vlan-id ] [ chassis chassis-number slot slot-number ] | vsi vsi-name ]
[ verbose ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
vlan vlan-id: Specifies a VLAN. The value range for the vlan-id argument is in the range of 1 to 4094. If
you do not specify a VLAN, this command displays IGMP snooping group information in all VLANs.
slot slot-number: Specifies a card by its slot number. If no slot is specified, the command displays the
IGMP snooping group information for the main processing unit (MPU). (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on a member device. The chassis-number
argument specifies an IRF member device ID, and the slot-number argument specifies a card by its slot
number. If this option is not specified, this command displays IGMP snooping group information for all
MPUs in the IRF fabric. (In IRF mode.)
verbose: Displays detailed IGMP snooping group information.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
This command is available only when the SAP module is used with MPU RPE-X1, RSE-X1, or RSE-X2.