R3303-HP HSR6800 Routers IP Multicast Command Reference

268
ip-address: Specifies the IP address of a BGP MDT peer.
Usage guidelines
Before you configure this command, BGP MDT peers or peer groups should be configured.
Your configuration will overwrite the old configuration (if any).
Examples
# Configure and activate BGP MDT peer group test, and then configure the local device as a route
reflector and specify the BGP MDT peer group test as a client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] group test
[Sysname-bgp] ipv4-family mdt
[Sysname-bgp-af-mdt] peer test enable
[Sysname-bgp-af-mdt] peer test reflect-client
Related commands
• peer enable
• reflect between-clients
• reflect cluster-id
reflect between-clients (BGP-MDT sub-address family view)
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
Syntax
reflect between-clients
undo reflect between-clients
Default
Route reflection between clients is enabled.
Views
BGP-MDT sub-address family view
Default command level
2: System level
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family mdt
[Sysname-bgp-af-mdt] undo reflect between-clients
Related commands
• peer reflect-client
• reflector cluster-id