R3303-HP HSR6800 Routers IP Multicast Command Reference

17
igmp-snooping host-aging-time
Use igmp-snooping host-aging-time to set the aging timer for the dynamic member ports in the current
VLAN.
Use undo igmp-snooping host-aging-time to restore the default.
Syntax
igmp-snooping host-aging-time interval
undo igmp-snooping host-aging-time
Default
The aging timer of the dynamic member ports is 260 seconds.
Views
VLAN view
Default command level
2: System level
Parameters
interval: Sets an aging time for the dynamic member port in seconds, in the range of 200 to 1000.
Usage guidelines
This command takes effect only if IGMP snooping is enabled in the VLAN.
Examples
# Enable IGMP snooping for VLAN 2 and set the aging timer for the dynamic member ports in the VLAN
to 300 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping host-aging-time 300
Related commands
• host-aging-time
• igmp-snooping enable
igmp-snooping host-join
Use igmp-snooping host-join to configure a port on the SAP module as a simulated member host for the
specified multicast group or the specified multicast source and group.
Use undo igmp-snooping host-join to remove a simulated member host from the specified multicast
group or the specified multicast source and group.
Syntax
igmp-snooping host-join group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping host-join group-address [ source-ip source-address ] vlan vlan-id