R3303-HP HSR6800 Routers IP Multicast Command Reference

279
RPF interface: GigabitEthernet2/1/1, RPF neighbor: 2002::201
Referenced prefix/prefix length: 2001::/64
Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
Table 64 Command output
Field Descri
p
tion
RPF information about source 2001::101 RPF information of the IPv6 multicast source 2001::101.
RPF interface Interface type and number of the RPF interface.
RPF neighbor IPv6 address of the RPF neighbor.
Referenced prefix/prefix length Referenced route and prefix length.
Referenced route type
Type of the referenced route:
• igp—IPv6 unicast route (IGB).
• egp—IPv6 unicast (EGP).
• unicast (direct) —IPv6 unicast route (directly connected).
• unicast—Other IPv6 unicast route (such as IPv6 unicast
static route).
• mbgp—IPv6 MBGP route.
Route selection rule
RPF route selection rule: an RPF route can be selected by the
priority of the routing protocol or by the longest match of the
destination address in the routing table.
Load splitting rule Load sharing rule.
Related commands
• display multicast ipv6 forwarding-table
• display multicast ipv6 routing-table
multicast ipv6 boundary
Use multicast ipv6 boundary to configure an IPv6 multicast forwarding boundary.
Use undo multicast ipv6 boundary to delete the specified IPv6 multicast forwarding boundary or all IPv6
multicast forwarding boundaries.
Syntax
multicast ipv6 boundary { ipv6-group-address prefix-length | scope { scope-id | admin-local | global |
organization-local | site-local } }
undo multicast ipv6 boundary { ipv6-group-address prefix-length | scope { scope-id | admin-local |
global | organization-local | site-local } | all }
Default
No multicast forwarding boundary is configured.