R3303-HP HSR6800 Routers IP Multicast Command Reference

282
Parameters
limit: Specifies the maximum number of entries in the IPv6 multicast forwarding table. The value range for
this argument is 0 to 1024.
Examples
# Set the maximum number of entries in the IPv6 multicast forwarding table to 200.
<Sysname> system-view
[Sysname] multicast ipv6 forwarding-table route-limit 200
Related commands
display multicast ipv6 forwarding-table
multicast ipv6 load-splitting
Use multicast ipv6 load-splitting to enable load splitting of IPv6 multicast traffic.
Use undo multicast ipv6 load-splitting to disable load splitting of IPv6 multicast traffic.
Syntax
multicast ipv6 load-splitting {source | source-group }
undo multicast ipv6 load-splitting
Default
Load splitting of IPv6 multicast traffic is disabled.
Views
System view
Default command level
2: System level
Parameters
source: Specifies IPv6 multicast load splitting on a per-source basis.
source-group: Specifies IPv6 multicast load splitting on a per-source and per-group basis.
Examples
# Enable load splitting of IPv6 multicast traffic on a per-source basis.
<Sysname> system-view
[Sysname] multicast ipv6 load-splitting source
multicast ipv6 longest-match
Use multicast ipv6 longest-match to configure RPF route selection based on the longest match principle,
namely, to select the route with the longest prefix as the RPF route.
Use undo multicast ipv6 longest-match to restore the default.
Syntax
multicast ipv6 longest-match
undo multicast ipv6 longest-match