R3303-HP HSR6800 Routers IP Multicast Command Reference

299
Table 73 Command output
Field Descri
p
tion
GigabitEthernet2/1/1(1::1) Interface and IPv6 address.
(10::1, FF1E::101) (S, G) entry.
Host Host IPv6 address.
Uptime Host running duration.
Expires Host expiration time, where "timeout" means that the host has expired.
fast-leave (MLD view)
Use fast-leave to configure MLD fast-leave processing globally.
Use undo fast-leave to disable MLD fast-leave processing globally.
Syntax
fast-leave [ group-policy acl6-number ]
undo fast-leave
Default
MLD fast-leave processing is disabled. That is, the MLD querier sends multicast-address-specific queries
or multicast-address-and-source-specific queries after receiving an MLD done message from a host,
instead of sending a leave notification directly to the upstream.
Views
MLD view
Default command level
2: System level
Parameters
acl6-number: Specifies a basic IPv6 ACL number in the range of 2000 to 2999. The fast-leave
processing function is effective only on the IPv6 multicast groups that match the permit statement in the
ACL. If you do not include this option in your command, this command takes effect on all IPv6 multicast
groups.
Usage guidelines
When this command is executed in MLD view, it is effective on all Layer 3 interfaces.
Examples
# Enable MLD fast-leave processing globally.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] fast-leave
Related commands
• last-listener-query-interval
• mld fast-leave