R3303-HP HSR6800 Routers IP Multicast Command Reference

309
Views
Interface view
Default command level
2: System level
Examples
# Configure GigabitEthernet 2/1/1 to discard MLD messages without the Router-Alert option.
<Sysname> system-view
[Sysname] interface gigabitethernet2/1/1
[Sysname-GigabitEthernet2/1/1] mld require-router-alert
Related commands
• mld send-router-alert
• require-router-alert
mld robust-count
Use mld robust-count to configure the MLD querier's robustness variable on the current interface.
Use undo mld robust-count to restore the default.
Syntax
mld robust-count robust-value
undo mld robust-count
Default
The MLD querier's robustness variable is 2.
Views
Interface view
Default command level
2: System level
Parameters
robust-value: Specifies an MLD querier's robustness variable in the range of 2 to 5.
Usage guidelines
The MLD querier's robustness variable defines the maximum number of attempts for transmitting MLD
general queries, multicast-address-specific queries, or multicast-address-and-source-specific queries in
case of packet loss due to network problems. A greater value of the robustness variable makes the MLD
querier "more robust", but results in a longer IPv6 multicast group timeout time.
The MLD querier's robustness variable determines the following values:
• The default number of MLD general queries the MLDv1/v2 querier sends on startup.
• The number of multicast-address-specific queries the MLDv1 querier sends after receiving an MLD
done message.
• The number of multicast-address-and-source-specific queries the MLDv2 querier sends after
receiving an MLD report that indicates relation changes between IPv6 multicast groups and IPv6
multicast sources.