R3303-HP HSR6800 Routers IP Multicast Command Reference

327
c-bsr (IPv6 PIM view)
Use c-bsr to configure the specified interface a C-BSR.
Use undo c-bsr to remove the related C-BSR configuration.
Syntax
c-bsr ipv6-address [ hash-length [ priority ] ]
undo c-bsr
Default
No C-BSR is configured.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
ipv6-address: Specifies the IPv6 address of the interface that will act as a C-BSR.
hash-length: Specifies a hash mask length in the range of 0 to 128. If you do not specify this argument,
the corresponding global setting is used.
priority: Specifies the priority of the C-BSR, in the range of 0 to 255. A larger value means a higher
priority. If you do not specify this argument, the corresponding global setting is used.
Usage guidelines
IPv6 PIM-SM must be enabled on the interface that you want to configure as a C-BSR.
Examples
# Configure the interface with an IPv6 address of 1101::1 as a C-BSR.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] c-bsr 1101::1
Related commands
• c-bsr hash-length
• c-bsr priority
• c-rp
• pim ipv6 sm
c-bsr admin-scope (IPv6 PIM view)
Use c-bsr admin-scope to enable IPv6 administrative scoping.
Use undo c-bsr admin-scope to disable IPv6 administrative scoping.
Syntax
c-bsr admin-scope
undo c-bsr admin-scope