R3303-HP HSR6800 Routers IP Multicast Command Reference

347
Views
Any view
Default command level
1: Monitor level
Parameters
ipv6-group-address: Specifies an IPv6 multicast group address in the range of FFxy::/16, where x and y
represent any hexadecimal numbers from 0 to F.
ipv6-source-address: Specifies an IPv6 multicast source by its IPv6 address.
prefix-length: Specifies the address prefix length. The default value is 128. For an IPv6 multicast group
address, the value range for this argument is 8 to 128. For an IPv6 multicast source address, the value
range for this argument is 0 to 128.
incoming-interface: Specifies an incoming interface.
interface-type interface-number: Specifies an interface by its type and number.
register: Specifies the register interface. This keyword is valid only if mode-type is not specified or is sm.
outgoing-interface: Specifies an outgoing interface.
include: Specifies an interface in the outgoing interface list.
exclude: Specifies an interface not in the outgoing interface list.
match: Specifies an interface that only exists in the outgoing interface list.
mode mode-type: Specifies an IPv6 PIM mode, where mode-type can have the following values:
• dm: Specifies IPv6 PIM-DM.
• sm: Specifies IPv6 PIM-SM.
• ssm: Specifies IPv6 PIM-SSM.
flags flag-value: Specifies a flag. The values of flag-value and their meanings are as follows:
• act: Specifies IPv6 multicast routing entries that have been used for routing data.
• bidir: Specifies IPv6 multicast routing entries created by IPv6 BIDIR-PIM.
• del: Specifies IPv6 multicast routing entries scheduled to be deleted.
• exprune: Specifies multicast routing entries containing outgoing interfaces pruned by other IPv6
multicast routing protocols.
• ext: Specifies IPv6 routing entries containing outgoing interfaces provided by other IPv6 multicast
routing protocols.
• loc: Specifies IPv6 multicast routing entries on that devices that directly connect to the same subnet
as the IPv6 multicast source.
• niif: Specifies IPv6 multicast routing entries containing unknown incoming interfaces.
• nonbr: Specifies routing entries with IPv6 PIM neighbor searching failure.
• rpt: Specifies routing entries on RPT branches where (S, G) prunes have been sent to the RP.
• spt: Specifies routing entries on the SPT.
• swt
: Specifies routing entries in the process of RPT-to-SPT switchover.
• wc:
Specifies wildcard routing entries.
fsm: Displays detailed information about the state machine.