R3303-HP HSR6800 Routers IP Multicast Command Reference

366
pim ipv6 state-refresh-capable
Use pim ipv6 state-refresh-capable to enable the state refresh feature on the interface.
Use undo pim ipv6 state-refresh-capable to disable the state refresh feature.
Syntax
pim ipv6 state-refresh-capable
undo pim ipv6 state-refresh-capable
Default
The state refresh feature is enabled.
Views
Interface view
Default command level
2: System level
Examples
# Disable state refresh on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] undo pim ipv6 state-refresh-capable
Related commands
• state-refresh-hoplimit
• state-refresh-interval
• state-refresh-rate-limit
pim ipv6 timer graft-retry
Use pim ipv6 timer graft-retry to configure the graft retry period.
Use undo pim ipv6 timer graft-retry to restore the default.
Syntax
pim ipv6 timer graft-retry interval
undo pim ipv6 timer graft-retry
Default
The graft retry period is 3 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies a graft retry period in seconds. The value ranges from 1 to 65535.