R3303-HP HSR6800 Routers IP Multicast Command Reference

371
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a register suppression time in seconds, in the range of 1 to 65535.
Examples
# Set the register suppression time to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-suppression-timeout 70
Related commands
• probe-interval
• register-policy
register-whole-checksum (IPv6 PIM view)
Use register-whole-checksum to configure the router to calculate the checksum based on the entire
register message.
Use undo register-whole-checksum to restore the default.
Syntax
register-whole-checksum
undo register-whole-checksum
Default
The checksum is calculated based only on the header in the register message.
Views
IPv6 PIM view
Default command level
2: System level
Examples
# Configure the router to calculate the checksum based on the entire register message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-whole-checksum
Related commands
• register-policy
• register-suppression-timeout